Kyocera FS-C8600DN - Page 454

2MN/2N1
2-3-16
YC7
21 SB_MOT_PD O 0/3.3 V DC EM control signal
Connected to
front PWB
22 SB_MOT_DIR O 0/3.3 V DC EM drive switch signal
23 GND - - Ground
24
WTNR_FULL I Analog WTS1 detection signal
25
THOP_DIR - - Not used
26 DLP_FAN_CLR_
H
O 0/24 V DC DEVFM1: On/Off
27 DLP_FAN_CLR_L O 0/24 V DC DEVFM1: On/Off
28 WTNR_SET I Analog WTS2 detection signal
29 WTNR_NEAR(M) I Analog WTS2 detection signal
30 WTNR_NEAR_V
CONT
O 0/3.3 V DC WTS2 control signal
31 GND - - Ground
32 ROT_MOT_REM - - Not used
33 ROT_MOT_CLK - - Not used
34 ROT_MOT_PD - - Not used
35 ROT_MOT_DIR - - Not used
36 ROT_SUB_SENS - - Not used
37 THOP_MOT_Bk - - Not used
38 THOP_MOT_M - - Not used
39 THOP_MOT_C - - Not used
40 THOP_MOT_Y - - Not used
41 GND - - Ground
42 ENCODE_ Bk - - Not used
43 ENCODE_M - - Not used
44 ENCODE_C - - Not used
45 ENCODE_Y - - Not used
46 THOP_ Bk - - Not used
47 THOP_M - - Not used
48 THOP_C - - Not used
49 THOP_Y - - Not used
50 GND - - Ground
Connector Pin Signal I/O Voltage Description