Kyocera KM-1500 - HUE - adjust HUE

2DC
1-6-37
1-6-15 Removing the scanner motor
1. Remove the original holder cover (See page
1-6-32).
2. Remove the left cover (See page 1-6-4).
3. Remove the one connector from the scanner
board.
Figure 1-6-43 Removing the scanner motor (1)
4. Remove two screws and then remove two
grounding plates.
Figure 1-6-45 Removing the scanner motor (3)
Connector
Scanner board
Screws
Scanner belt
Grounding plates
Screw
Screw
Figure 1-6-44 Removing the scanner motor (2)
5. Loosen two screws and then release the
tension of a scanner belt.
6. Remove the scanner belt.