2DC
1-6-42
Yes
No
Start
Enter maintenance mode.
Enter “034” using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Press the program key.
Press the start key
to output a test pattern.
Is the image correct?
Press the start key.
The new setting is stored.
Press the stop/clear key to exit
maintenance mode.
End
For output example 1, increase
the value using the zoom (+) key.
For output example 2, decrease
the value using the zoom (–) key.
Setting range: –1.0 – +3.0
Initial setting: 0.0
Changing the value by 1 moves the
center line by 1 mm.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 3 (lit): Center line from the drawer
Exp. 1 (flashing): Center line from
the bypass tray
Exp. 2 (flashing): Center line from
the optional drawer
(2) Adjusting the center line of image printing
Make the following adjustment if there is a regular error between the center lines of the copy image and original when
paper is fed from the drawer.
U034
U067
(P. 1-6-48)
U072
(P. 1-6-52)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Center line of printing
Correct image Output
example 1
Output
example 2
Figure 1-6-52
To Next Page
Loading...
