Kyocera KM-1500 - Adjusting the Margins for Printing

2DC
1-6-43
(3) Adjusting the margins for printing
Make the following adjustment if the margins are not correct.
U402
U403
(P. 1-6-49)
U404
(P. 1-6-54)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Ejection direction
(reference)
Printer leading edge margin
(3 ± 2.5 mm)
Printer
left margin
(2.0
+2.0
mm)
Printer
right margin
(2.0
+2.0
mm)
Printer trailing edge margin
(
3 ± 2.5 mm
)
–1.5–1.5
Yes
No
Start
Enter maintenance mode.
Enter “402” using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Press the start key
to output a test pattern.
Press the start key.
The new setting is stored.
Setting range (initial setting/change in value per step)
Printer leading edge margins: 0 – +10 (3.0/0.5 mm)
Printer left/right margin: 0 – +10 (3.5/0.5 mm)
Printer trailing edge margin: –5 – +10 (3.5/0.5 mm)
Select the item to be adjusted using
the copy exposure adjustment keys.
Are the margins correct?
Change the setting.
Increasing the value using the zoom (+)
key makes the margin wider.
Decreasing the value using the zoom (–)
key makes the margin narrower.
Press the program key and the
machine enters the test copy mode.
Yes
No
Press the stop/clear key to
exit maintenance mode.
End
Proceed to
another mode?
Exp. 1 (lit): Printer leading edge margin
Exp. 2 (lit): Printer left/right margins
Exp. 3 (lit): Printer trailing edge margin
Figure 1-6-53