Kyocera KM-1500 - Adjusting the DP Leading Edge Registration

2DC-2
1-6-51
(11) Adjusting the DP leading edge registration
Perform the following adjustment if there is a regular error between the leading edge of the original and the copy image.
U034
(P. 1-6-41)
U066
(P. 1-6-47)
U071
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Press the start key.
Enter “071” using the copy exposure
adjustment keys or zoom +/- keys.
Yes
No
Start
End
• For copy example 1,
decrease the value using
the zoom (-) key.
• For copy example 2,
increase the value using
the zoom (+) key.
Press the program key and the
machine enters the test copy mode.
Press the stop/clear key
to exit maintenance mode.
Place an original on the
DF and make a test copy.
Is the image correct?
Setting range: –32 – +32
Initial setting: 12
Changing the value by 1 moves
the copy image by 0.254 mm.
Press the start key.
The new setting is stored.
Select “Exp. 1” (DP leading edge
registration) using the copy
exposure adjustment keys.
Original
Copy
example 1
Copy
example 2
Figure 1-6-61