Kyocera KM-1650 - Destination Registration (PC)

2DA/2DB-3.0
1-4-13
U053
*1: Optional. *2: Optional for 16 ppm model. Standard for 20 ppm model.
MAIN MOTOR
Increasing the setting makes the image longer in the auxiliary scanning direction, and decreasing it
makes the image shorter in the auxiliary scanning direction.
POLYGON MOTOR
Increasing the setting makes the image longer in the main scanning direction and shorter in the auxiliary
scanning direction; decreasing the setting makes the image shorter in the main scanning direction and
longer in the auxiliary scanning direction.
3. Press the start key. The value is set.
Interrupt copy mode
While this maintenance item is being performed, a VTC pattern shown below is output in interrupt copy mode.
1. Press the interrupt key. The machine enters the interrupt copy mode.
2. Press the start key. A VTC pattern is output.
To return to the screen for setting, press the interrupt key.
Correct values for an A3/11" x 17" output are:
A = 300
± 1.5 mm
B = 270
± 1.35 mm
Figure 1-4-1
Adjustment
1. Output an A3/11" x 17" VTC pattern in interrupt copy mode.
2. Measure A and B on the VTC pattern (Figure 1-4-1), and perform the following adjustments if they are
different from the correct sizes:
A: Drive motor speed adjustment
B: Polygon motor speed adjustment
Completion
Press the stop/clear key at the screen for setting. The screen for selecting a maintenance item No. is dis-
played.
Maintenance
item No.
Description
Display Description Setting range Initial setting
RES1 Trailing edge registration motor correction
(paper feed from drawer)
0 to +5.0 0.0
RESB Trailing edge registration motor correction
(paper feed from bypass tray)
0 to +5.0 0.0
RES2 Trailing edge registration motor correction
(paper feed from first paper feeder
*2
)
0 to +5.0 0.0
RES3 Trailing edge registration motor correction
(paper feed from second paper feeder
*1
)
0 to +5.0 0.0
RES4 Trailing edge registration motor correction
(paper feed from third paper feeder
*1
)
0 to +5.0 0.0
RESD Trailing edge registration motor correction
(paper feed from duplex section
*1
)
0 to +5.0 0.0