Using COMMAND CENTER
6-5
Start Page
The following operations are possible from the Start page.
• Verifying the machine’s operating status
• Changing the language that COMMAND CENTER is displayed in
• Verifying various settings (machine, printing, scanning, network and e-mail)
• Verifying the number of scanned pages and the number of printouts that have been made on
the machine
• Access linked home pages
All users will have read privileges to the Start page.
Start > Start Page
This page allows you to verify the machine’s operating status. This will be the first screen that
appears after COMMAND CENTER has been started up.
Note To return from any other page to this home page (the first screen that appears after COMMAND
CENTER has been started up), click on T Start.
Item Description
Select Language Appears if COMMAND CENTER pages support multiple languages.
Supported languages may also be selected through language preference
settings in your browser.
To change COMMAND CENTER language:
1 Open the Select Language drop down list by clicking it.
2 Select the appropriate language.
If you attempt to view COMMAND CENTER with a character set other than
the language that is used on the operation panel’s message display, some
characters may be illegible.
Operation Panel This indicates the machine’s operating status as displayed on the operation
panel. To update the display to the most recent status, click the Refresh
button.
Toner Level This shows the approximate level of remaining toner. When the value is
100 %, the toner container is full. The closer to 0 %, the smaller the amount
of remaining toner.
General Information This allows you to verify the following information: IP Address, Host Name,
MAC Address, System Firmware, Engine Firmware, Serial Number, and
Asset Number.
Media Input This shows paper size and media type for cassettes and MP tray.
To Next Page
Loading...
