Using COMMAND CENTER
6-12
Advanced Page
This section includes advanced settings that apply to the machine and is comprised primarily of
advanced network settings. Pages in this section are available only to the Administrator (if the
Admin password has been set).
Note Always restart this machine after you have completed these settings in order to properly register the
content of those settings in the machine. Refer to Basic > Reset Page on page 6-9.
Advanced > Protocols > TCP/IP > General
The table below provides a summary of the items displayed on the Printer System page.
Advanced > Protocols > TCP/IP > IP Filters
IP filters specify a host or network of hosts that are allowed to access the printing system. An entry
should be a network number or host IP address. Up to 10 access list entries are allowed.
• When there are no entries, access is allowed to all hosts.
• To allow all hosts on network 192, enter 192.0.0.0 and 255.0.0.0.
• To allow only a host 192.168.1.2, enter 192.168.1.2. The default mask 255.255.255.255 is
assumed and subnet mask can be left blank.
Advanced > Protocols > TCP/IP > Logical Printers
Logical Printers allows you to use this machine as four virtual printers, each with customized
features such as ASCII to Postscript conversion, and the addition and/or replacement of character
strings (commands) at the beginning or end of job data.
Item Description
Host Name Specifies a name for the printing system network component. This name is
also used as the NetBEUI Printer Name and the SNMP sysName object.
IP Address Assigns the Internet Protocol address on the printing system network
component. Format of the IP Address is four-byte (32-bit) numbers
separated by dots, e.g. 192.168.110.171.
Subnet Mask Specifies the subnet mask configured on the printing system network
component. If the printing system does not automatically assign a usable
default value and the first number in the IP address above is from 192 to
254, then use 255.255.255.0 as the subnet mask.
Default Gateway The IP address of the gateway router for the local network.
DHCP/BOOTP,
RARP
Identifies how the machine obtains its IP configuration: DHCP/BOOTP:
automatic configuration via a BOOTP server or a DHCP server. RARP:
automatic configuration via the Reverse Address Resolution Protocol.
DNS Server (Primary,
Secondary)
The IP address of the primary and secondary Domain Name System (DNS)
servers.
Domain Name The Domain Name System (DNS) name of the domain which the printing
system belongs, such as kyoceramita.com. It should not include host printer
name.
WINS Server
(Primary, Secondary)
The IP address of the primary and secondary Windows Internet Name
Service (WINS) servers.
Scope ID This section determines the scope of IP addresses that a Windows server
can grant or lease to any requesting network component. A DHCP server
processes the printing system’s discovery broadcasts and returns an IP
address to it. The DHCP server may be set up to grant an IP address for a
limited time (a temporary lease) or for an unlimited time (an unlimited lease),
or it may be configured with a permanent address reservation for the printing
system.
To Next Page
Loading...
