Using COMMAND CENTER
6-15
sysName The MIB-II sysName object, usually the host or domain name of the printing
system.
sysLocation The MIB-II sysLocation object, usually the location information of the printing
system.
Authentication Traps Check On to enable or Off to disable the MIB-II EnableAuthenTrap object. If
enabled, an SNMP trap is generated when an attempt to read or write is
made using an incorrect community name. The trap is sent to the configured
trap address.
Trap Community The SNMP trap community name to be used when the printing system
generates a trap.
Trap IP Address The IP address which will receive the trap.
Selected Errors Select the events which will cause a trap to be generated including Add
Paper, Low Toner, Add Toner, Cover Open, Paper Jam, and All Other Errors.
Item Description
To Next Page
Loading...
