Kyocera KM-1815 - Continuous Copying

Copying Functions
1-19
Continuous Copying
Use Continuous Copying to scan originals into memory in individual sections.The machine then
groups the sections together to form a single job. The copies are then produced in one batch, as a
single job.
Selecting Continuous Copying
Perform the following procedure to turn continuous copying on.
1
Press the Copy key. The copy basic screen is displayed.
2
Press the Function key.
3
Press the S key or the T key to select Continuous
Scan and press the Enter key. The Continuous
Scan screen is displayed.
4
Press the S key or the T key to select On and press
the Enter key. The message display shows
Completed and returns to the Function screen.
5
Press the right select key. The message display returns to the copy basic screen. To start
continuous copying, refer to the section which follows.
Using Continuous Copying
Perform the following procedure to use continuous copying.
Note The maximum number of originals to scan depends on the available memory in the machine.
Number of scannable originals (Letter, 5 %, Text+Photo mode) are as follows:
• 96 MB (standard): Approximately 70 sheets
• 128 MB: Approximately 115 sheets
• 192 MB: Approximately 380 sheets
• 320 MB: Approximately 535 sheets
*
Orig. Placement
EcoPrint
Continuous Scan
Function:
Exit
*
Continuous Scan:
*
Cancel
Off
On