Scanning Functions
2-3
Scanning Documents
Perform the following procedure in order to use this machine to scan documents.
1
Press the E-Mail key. The scanner basic screen is displayed.
2
Press the one-touch key on which the destination
e-mail address is registered. The e-mail address is
displayed.
Note To cancel the e-mail address, press the W key.
3
Program the settings as required to use additional functions which are explained on pages 2-6 to
2-20.
4
Press the Start key. The Scanning screen is
displayed and the scanning will begin.
5
If Continuous Scan was selected, the message Set
original and press Start key displays when
scanning is completed. Refer to Continuous
Scanning on page 2-14.
To scan another original, position the next original and
change the settings as required. Press the Start key.
When all the originals have been scanned, press the
right select key.
Notes • The Sender of the e-mail will be listed as the information that is registered under the Sender
Address setting in COMMAND CENTER (the internal HTML page).
• A default subject and body message for e-mail can be selected in advance by using
COMMAND CENTER.
Entering the E-mail Address Using the Operation Panel
Perform the following procedure to enter the destination of the e-mail address from the operation
panel.
1
Press the E-Mail key. The scanner basic screen is displayed.
:h_pttr@owl-net.net
Ready to send.
Dest.
SubjectPlacemnt
Left On
:1
*
Set original
Page:
Cancel
Job No.:
6
123
and press Start key.
End Scan
To Next Page
Loading...
