Printer Settings
3-2
Using the Machine as a Network Printer
The procedure to use this machine as a network printer is accomplished in accordance with the
following flow.
Enter IP addresses, etc. for a network connection
È
Connect the network cable
(Refer to Chapter3, Connecting the Cables in Basic Operation Guide)
È
Perform the following procedures on the operation panel or COMMAND CENTER (Refer to Using
COMMAND CENTER on page 6-1.)
• Make the network settings (page 3-4)
• Select the emulation mode (page 3-9)
• Set the number of prints and select the original placement
• Select the original quality mode
• Register the paper sizes for the cassette(s) and MP tray
È
Install and set-up the printer driver
(Refer to KX Printer Driver Guide).
È
Print out from the application
To Next Page
Loading...
