Printer Settings
3-3
Parallel Setting
The parallel interface supports a bi-directional/high-speed mode according to IEEE standards. Four
modes are available.
Note Use a parallel printer cable that complies with the IEEE1284 standard.
1
Press the System Menu/Counter key. The System Menu/Count screen is displayed.
2
Press the S key or the T key to select System
Setting and press the Enter key. The System
Setting screen is displayed.
3
Press the S key or the T key to select Parallel
Setting and press the Enter key. The Parallel
Setting screen is displayed.
4
Press the S key or the T key to select the desired
parallel interface mode setting and press the Enter
key. The message display shows Completed and
returns to the System Setting screen.
Item Description
Auto (default) The machine automatically changes its communication mode to the
one the host computer is currently using. Ordinarily, you should leave
this setting unchanged.
Normal The machine uses the standard communication method prescribed for
Centronics interfaces.
High speed This mode enables faster data transmission between the machine and
the host computer. (Select this mode if printing problems occur when
the machine is connected to a workstation.)
Nibble(high) High speed data communication is used in compliance with the IEEE
1284 standard.
*
Sys. Menu/Count.:
Counter
System Setting
Report
Exit
*
System Setting:
Back
Network Setting
Parallel Setting
Exit
*
Parallel Setting:
Cancel
*
Normal
Auto
High Speed
To Next Page
Loading...
