Printer Settings
3-7
3
Use the keypad to enter the IP address. Enter the first
segment of the IP address.
4
Press the X key and enter second segment of the IP
address.
5
Continue the same procedure for the remaining
segments of IP address. Once the IP address has
been entered, press the Enter key. The message
display shows Completed and returns to the TCP/IP
Setting screen.
Note If you make an error in entering a portion of the IP address, press the W key to return to the previous
block of digits and reenter the correct number.
Subnet Mask Setting
Specifies the Subnet Mask configured on the printing system network component. If the printing
system does not automatically assign a usable default value and the first number in the IP address
above is from 192 to 254, then use 255.255.255.0 as the Subnet Mask.
Perform the following procedure to register the Subnet Mask address.
If you are not sure of the appropriate Subnet Mask address, contact your network administrator.
1
Access the TCP/IP Setting screen.
2
Press the S key or the T key to select Subnet Mask
and press the Enter key. The Subnet Mask screen is
displayed.
3
Enter the Subnet Mask address in the same manner as you did for the IP address in steps 3 through
5 of IP Address Setting.
IP Address:
Cancel
0. 0. 0. 0
IP Address:
Cancel
10. 0. 0. 0
IP Address:
Cancel
168. 0. 010.
IP Address:
Cancel
168. 0. 12310.
TCP/IP Setting:
DHCP
IP Address
Exit
Subnet Mask
To Next Page
Loading...
