5-1
5 System Settings
This chapter explains the procedures to make the various settings that are required in
relation to the overall operation of this machine.
This chapter explains the following topics:
• Adjusting the Contrast of Message Display
• Message Language
• Default Operation Mode
• Unit of Measurement
• Adjusting Copy Exposure
• Turning Scan Noise Reduction On and Off
• Photo Processing Method
• Resetting Toner Status
• Changing Function Defaults
• Registering Destination E-mail Addresses
• Restarting the Machine
• Adjusting Alarms
• Date and Time
• Date Format
• Time Zone
• Summer Time
• Auto Panel Reset
• Low Power Timer
• Auto Sleep Timer
•Auto Error Clear
• Registering Custom Original Size
• Registering Custom Paper Size
• Default Original Size
• Selecting Paper Size and Media Type
• Registering Custom Media Type
• Selecting the Paper Feed Source
• Selecting the APS (Auto Paper Selection) Media Type
• Printing the Service Pages
Note
Some of the procedures above can also be accomplished using COMMAND CENTER. For those
procedures available using COMMAND CENTER, refer to Using COMMAND CENTER on
page 6-1.
To Next Page
Loading...
