Kyocera KM-2530 - Page 139

Maintenance
Description
item No.
2DF
1-4-46
U332 Setting the size conversion factor
Description
Sets the factor for converting each paper size into A4/11" × 8
1
/
2
". The black ratio is converted for the A4/11" ×
8
1
/
2
" size using the factor set in this maintenance item. Values set are displayed in the user simulation.
Purpose
To set the factor to convert the black ratio of each paper size for A4/11" × 8
1
/
2
" size.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the paper size.
3. Change the setting using the cursor up/down keys.
The size conversion factor can be set separately for the copier mode (COPY), the printer mode (PRI) and
the fax mode (FAX) at the screen for setting the size conversion factor.
Metric models
Display Description Setting
Initial setting
COPY PRI FAX
A3 Size conversion factor for A3 0.0 to 3.0 2.0 2.0 2.0
B4 Size conversion factor for B4 0.0 to 3.0 1.5 1.5 1.5
A4 Size conversion factor for A4 0.0 to 3.0 1.0 1.0 1.0
B5 Size conversion factor for B5 0.0 to 3.0 0.7 0.7 0.7
A5 Size conversion factor for A5 0.0 to 3.0 0.5 0.5 0.5
B6 Size conversion factor for B6 0.0 to 3.0 0.4 0.4 0.4
FOLIO Size conversion factor for folio 0.0 to 3.0 0.3 0.3 0.3
OTHER Size conversion factor for non-standard sizes 0.0 to 3.0 1.0 1.0 1.0
Inch models
Display Description Setting
Initial setting
COPY PRI FAX
11 × 17 Size conversion factor for 11" × 17" 0.0 to 3.0 2.0 2.0 2.0
8.5 × 14 Size conversion factor for 8.5" × 14" 0.0 to 3.0 1.5 1.5 1.5
8.5 × 11 Size conversion factor for 8.5" × 11" 0.0 to 3.0 1.0 1.0 1.0
5.5 × 8.5 Size conversion factor for 5.5" × 8.5" 0.0 to 3.0 0.7 0.7 0.7
OTHER Size conversion factor for non-standard sizes 0.0 to 3.0 0.5 0.5 0.5
4. Press the start key. The setting is set.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item is displayed.
U341 Specific paper feed location setting for printing function
Description
Sets a paper feed location specified for printer output (only if a printer kit is installed).
Purpose
To use a paper feed location only for printer output.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the paper feed location for the printer. The selected item is displayed in reverse.
Display Description
FIRST Upper drawer
SECOND Lower drawer
THIRD Optional upper drawer
FOURTH Optional lower drawer
LCF Optional large paper deck
3. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item is displayed.