Maintenance
Description
item No.
2DF
1-4-52
U905 Checking/clearing counts by optional devices
Description
Displays or clears the counts of the optional DF or finisher.
Purpose
To check the use of the DF and finisher. Also to clear the counts after replacing consumable parts.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the device, the count of which is to be checked and press the start key. The count of the selected
device is displayed.
•DF
Display Description
CHANGE Original replacement count
ADF No. of single-sided originals that has passed through the DF in ADF mode
RADF No. of double-sided originals that has passed through the DF in RADF mode
• Finisher (SORTER)
Display Description
CP CNT No. of copies that has passed
STAPLE Frequency the stapler has been activated
PUNCH Frequency the punch has been activated
STACK Frequency the stacker has been activated
Clearing
1. Select the item to be cleared. The selected item is displayed in reverse.
2. Press the start key. The count is cleared.
3. To return to the screen for selecting an item, press the stop/clear key.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item No. is
displayed.
U906 Resetting partial operation control
Description
Resets the service call code for partial operation control.
Purpose
To be reset after partial operation is performed due to problems in the drawers or other sections, and the
related parts are serviced.
Method
1. Press the start key.
2. Press EXECUTE on the touch panel.
3. Press the start key to reset partial operation control. The maintenance mode is exited, and the machine
returns to the same status as when the main switch is turned on.
To Next Page
Loading...
