Kyocera KM-2540 - Setting DP Reading Position Modification Operation

2JB/2JC
1-3-28
U087
Setting DP reading position modification operation
Description
The presence or absence of dust is determined by comparing the scan data of the original trailing edge and
that taken after the original is conveyed past the DP original scanning position. If dust is identified, the DP
original scanning position is adjusted for the following originals.
Purpose
When using optional DP, to solve the problem when black lines occurs due to the dust with respect to original
reading position.
Method
1. Press the start key.
2. Select the item.
Setting: Standard data when dust is detected
1. Change the value using the cursor up/down keys.
2. Press the start key. The value is set.
Setting: Initialization of original reading position
1. Select [CLEAR].
2. Press the start key. The setting is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
Setting
range
Initial set-
ting
CCD Setting of standard data when dust is detected. 10 to 95 35
BLACK LINE Initialization of original reading position. - -