Kyocera KM-2540 - Checking DP Operation; Setting the Presence or Absence of a Key Card or Key Counter

2JB/2JC
1-3-42
U203
Checking DP operation
Description
Simulates the original conveying operation separately in the optional DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the item to be operated.
4. When selecting [ADF] or [RADF], to set the magnification using the cursor up/down keys.
5. Press the start key. The operation starts.
6. To stop continuous operation, press the stop/clear key.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U204
Setting the presence or absence of a key card or key counter
Description
Sets the presence or absence of the optional key card or key counter.
Purpose
To run this maintenance item if a key card or key counter is installed.
Setting
1. Press the start key.
2. Select the optional counter to be installed.
3. Press the start key. The setting is set and the screen for selecting a maintenance item No. is displayed.
4. Turn the main power switch off and on.
Maintenance
item No.
Description
Display Operation Setting range Initial setting
ADF With paper, single-sided original 100 to 200 (%) 100
RADF With paper, double-sided original 100 to 200 (%) 100
ADF (NON P) Without paper, single-sided original
(continuous operation)
--
RADF (NON P) Without paper, double-sided original
(continuous operation)
--
Display Description
KEY-CARD The key card is installed.
KEY-COUNTER The key counter is installed.