2JB/2JC
1-3-43
U206
Setting the presence or absence of the coin vender
Description
Sets the presence or absence of the optional coin vender. Also sets the details for coin vender operation, such
as mode and unit price.
This is an optional device which is currently supported only by Japanese specification machines, so no setting
is necessary.
U207
Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. COUNT0 is displayed and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the bot-
tom, the figure shown on the touch panel increases in increments of 1. When all the keys in that line are
pressed and if there are any LEDs corresponding to the keys in the line on the immediate right, the top
LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U233
Limiting job separator output
Description
Sets a limit of number of output pages from the optional job separator.
Purpose
Settings may be modified if curled paper is output from the job separator.
Setting
1. Press the start key.
2. Select the mode.
Initial setting: MODE0
3. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
MODE 0 All sizes: 100 sheets
MODE 1 A3 and 11 x 17" sizes: 70, other sizes: 100
MODE 2 A3 and 11 x 17" sizes: 50, other sizes: 100
To Next Page
Loading...
