Various Settings and Registration 6-1
6 Various Settings and
Registration
This section contains explanations on making settings and
registering information.
Automatically Switching Between the Fax and a Telephone
(Auto FAX/TEL Switching) 6-3
Automatically Switching Between the Fax and an
Answering Machine (TAD Reception) 6-5
Using Different Fax and Telephone Numbers (D.R.D.
Reception) [Available in inch versions only] 6-7
Turning Print Out of Each Report ON/OFF (Print Report
setting) 6-9
Turning the Bulletin Board ON/OFF (Bulletin Board setting) 6-11
Setting the Number of Rings [Auto Fax Reception] (Number
of Rings setting) 6-12
Making Volume Settings (Volume setting) 6-13
Setting the Number of Redial Attempts (Number of Redials
setting) 6-14
Setting the Document Size for Scanning from the
Document Processor (Scan from DP setting) 6-15
Setting the Default Transmission Mode (TX Mode/Default
setting) 6-16
Selecting the Automatic Reception Mode (Receive Mode
setting) 6-17
Turning Reception Date & Time Print Out ON/OFF (RX
Date/Time setting) 6-18
Selecting the Paper Feed Selection Mode (Fax Paper
Feeding Tray setting) 6-19
Turning Manual Paper Feed ON/OFF (MP Tray setting) 6-21
Turning Duplex Reception ON/OFF (Duplex RX setting) 6-22
Turning 2 in 1 Reception ON/OFF (2 in 1 RX setting) 6-23
Turning Remote Diagnosis ON/OFF (Remote Diagnosis
setting) 6-24
Registering the Remote Test ID (Remote Test ID setting) 6-25
Receiving faxes at the same size or a reduced size
(Reception Size setting) 6-26
Restricting Communication To/From Specific Destinations
(TX/RX Restriction) 6-27
Registering New Permit Fax Numbers ................................. 6-28
Modifying or Deleting Permit Fax Numbers.......................... 6-29
Registering New Permit IDs ................................................. 6-30
Modifying or Deleting Permit IDs.......................................... 6-30
To Next Page
Loading...
