6-42 Various Settings and Registration
4 Refer to Printing Out Documents from an Encryption Box on page 6-
42, and print out the received documents from the corresponding
Encryption Box.
Printing Out Documents from an Encryption Box
Perform the following procedure to print out documents that have been
received into your Encryption Box. If the documents are printed out
correctly, the data will be deleted from that box.
1 Press the [Application] key. The Application screen will appear.
2 Press the [Print encr data box] ([Encry.code box output]) key.
3 Press the key that corresponds to the desired Encryption Box if it is
highlighted. If the key is not highlighted, there are no documents in
that box.
> If the Box ID is other than ‘0000’...
4 Enter the Box ID (4 digits) that corresponds to that Encryption Box.
5 Press the [Confirm] key. The documents that are in that Encryption
Box will be printed out.
Note If you registered ‘0000’ as the Box ID for your Encryption
Box, it is not necessary to enter a Box ID just to print out
documents from that box. In this case, only the box number you
enter needs to be correct in order to print out your documents.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
Place the original & assign destination.
Dest
Ready for fax transmission.
Basic Application
Abbrev.
TXAddress
Register
settingbook
Print Report
RX Polling
TX Polling
Basic Application Register
box input
Sub.conf.
TX status
Reserved
on LCD
TX result
on LCD
RX result
data box
Print encr
box output
Sub.conf.
Print Report
Option screen
Select item.
Encryption box
0352.
There are originals saved in the box which is highlighted.
B
Print encryption data box.
9876.
Note If you registered ‘0000’ as the Box ID, proceed directly
to step 6. If you registered any other Box ID, go to the next
step.
( 4 digits)
Enter box id using # key.
Box ID confirmation Ba
Print encryption data box.
Encryption box
_.
02.
To Next Page
Loading...
