Reference Information 8-11
Error Code Tables
When a communications error occurs, one of the following error codes
will be printed out on the corresponding Transmission Report or
Reception Report as well as the Activity Report.
Refer to the following tables for a more detailed explanation of the error.
Note If an error occurs during V34 communication, the ‘U’ in the
error codes noted below will change to an ‘E’.
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
Busy The line is busy or the other party does not answer after automatically redialing the set
number of times.
Perform transmission or reception procedures again.
Stopped Transmission has been interrupted by pressing the Stop/Clear key.
Reception has been interrupted by pressing the Stop/Clear key.
During multiple communication (Broadcast Transmission, Polling Reception, etc.), this unit
was unable to transmit to all destinations due to a communications interruption.
U00300 The destination FAX has run out of recording paper. Check with the destination party.
U00420 - U00462 Connection was made on a call initiated by the transmitting party, but the transmission has
been interrupted because the transmitting party does not possess the necessary
communication capabilities.
U00600 - U00690 Communication was interrupted due to trouble with your unit. Perform transmission or
reception procedures again.
U00700 Communication was interrupted due to trouble with the other party’s FAX unit. Check with the
other party.
U00800
U00810
Unsuccessfully transmitted page(s) remain. Perform transmission procedures again.
U00900
U00910
Unsuccessfully received page(s) remain. Perform reception procedures again.
U01000 - U01092 A communication error occurred during transmission. Perform transmission procedures
again.
U01100 - U01199 A communication error occurred during reception. Perform reception procedures again.
U01400 A communication which uses the timer was scheduled, and a number was entered using an
abbreviated number or one-touch key, etc., but communication with that party was impossible
because that number was no longer registered when the scheduled time arrived. Check your
unit.
Or, communication with that party was impossible because the number included a pound sign
(#) and it was registered with the Line Type setting set to “Tone Line”, but the Line Type
setting had been changed to “Pulse Line” at the time you attempted that communication.
U01500 A communication error occurred during transmission at high transmission speed. Perform
transmission procedures again.
U01600 A communication error occurred during reception at high transmission speed. Perform
reception procedures again after having the transmitting party lower the transmission speed.
U01700
U01720
A communication error occurred during transmission at high transmission speed. Perform
transmission procedures again.
U01721 A communication error occurred during transmission at high transmission speed. The
destination party’s FAX may not have the corresponding high speed reception capabilities. If
the destination party’s FAX number was dialed using an abbreviated number or one-touch
key, change the transmission speed registered for that number to a lower setting and perform
transmission procedures again.
U01800 - U01820 A communication error occurred during reception at high transmission speed. Perform
reception procedures again after having the transmitting party lower the transmission speed.
To Next Page
Loading...
