Kyocera KM-2540 - Force-Starting the Communication; Deleting the Communication

Fax Operation (Advanced) 3-17
4 Press the [Print] key.
5 Press the [Yes] key. A sample image of the corresponding
documents will be printed out.
Force-Starting the Communication
You can force-start a communication that is waiting in memory, without
having to wait for the scheduled start time.
1 Perform steps 1 through 3 of Printing Out a Sample Image of Waiting
Documents on page 3-16.
2 Press the [Immediate TX] key.
3 Press the [Yes] key. The corresponding operation will begin
automatically.
Deleting the Communication
You can delete a scheduled communication that is in memory and
waiting for a start time.
1 Perform steps 1 through 3 of Printing Out a Sample Image of Waiting
Documents on page 3-16.
2 Press the [Delete] key.
3 Press the [Yes] key. The selected communication will be deleted and
the touch panel will return to the initial mode settings.
If you want to continue deleting other scheduled communications,
repeat steps 1 through 3.
Close
n
status.
Memory usage:
JUN-06-2007 16:00
1/2.
end
T
X No.of pages: 001.
.0%
001.(No.party: )
Delete
Change
Program/
Print
TX
Immediate
Note You can also force-start a communication that is waiting for
Automatic Redialing.
You cannot, however, force-start a Polling Transmission.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
Close
n
status.
Memory usage:
JUN-06-2007 16:00
1/2.
end
T
X No.of pages: 001.
.0%
001.(No.party: )
Delete
Change
Program/
Print
TX
Immediate
Note You CANNOT delete a scheduled communication that is in
memory waiting to be forwarded to a destination fax.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
Close
n
status.
Memory usage:
JUN-06-2007 16:00
1/2.
end
T
X No.of pages: 001.
.0%
001.(No.party: )
Delete
Change
Program/
Print
TX
Immediate