Chapter 3 Error Correction 3-3
2. Insert the leading edge of roll paper under the under the Guide Plate (1) until the edge touches
the feeding roller.
Rotate the Paper Feeding Knob (2) clockwise so that the feeding rollers catch the roll paper.
3. When the feeding rollers catch the paper, hold and pull the dent part (4) to the arrow direction
to open the paper guide, and rotate the Paper Feeding Knob (2) until the leading edge comes
out from the slit about 10cm.
NOTE
(1) If the leading edge is extremely torn or folded, cut it off with a cutter or scissors.
(2) Rotate the Paper Feeding Knob of rear
side (3) for the Roll 2.
1
2
3
4
Leading edge
of roll paper
2
To Next Page
Loading...
