3-2-6
2A3/4
Developing
Fixing and
cleaning
Operation
panel and
support
equipment
Mode
setting
U156 Changing the toner control level
Toner feed start level
Toner empty level
U157 Checking/clearing the developing drive time
U158 Checking/clearing the developing count
U160 Applying toner to the cleaning blade
U161 Setting the fixing control temperature
Normal stabilization control temperature
Primary stabilization temperature
Secondary stabilization temperature
Aging time after secondary stabilization
U162 Stabilizing fixing forcibly
U196 Turning the fixing heater on
U198 Setting the fixing phase control
U200 Turning all LEDs on
U201 Initializing the touch panel
U202 Setting the MMD host monitoring system
U203 Operating DF separately
U204 Setting the presence or absence of a key card or
key counter
U206 Setting the presence or absence of the coin vender
U209 Setting date and time
U243 Checking the operation of the DF motors, clutches
and solenoids
U244 Checking the DF switches
U245 Checking messages
U247 Checking the operation of the large paper deck and
paper feed desk
U248 Setting the paper eject device
• Adjustment of the amount of slack in the paper in
punch mode
• Punch limit
• Punch-hole scrap count
• Booklet stitcher stapling position adjustment
U250 Setting the maintenance cycle
U251 Checking/clearing the maintenance count
U252 Setting the destination
U253 Switching between double and single counts
114
20
—
—
—
42ppm 52ppm
180 190
175 175
180 190
60 120
—
—
ON
—
—
—
—
—
OFF
—
—
—
—
—
0
75000
—
0
150
—
—
SINGLE
COUNT
Section
Item
Maintenance item contents
Initial
No. setting*
* Initial setting for executing maintenance item U020
To Next Page
Loading...
