2A3/4
3-3-88
( 4 ) Adjusting the side registration amount
Perform the following adjustment if paper is fed askew during refeed from the duplex
unit.
<Procedure>
Enter maintenance mode.
Enter "052" using the numeric keys.
Yes
No
Start
Press the print key.
Select "STEPPER DATA."
Press "TEST RUN."
Press the interrupt key to
make a test copy using
A3/11" x 17" paper.
Is gap A between
the paper and the side
registration front guide
within 1 mm?
Press the print key.
The new setting
is stored.
After paper is stocked in the duplex
unit, open the unit and move the
paper all the way to the
side registration rear guide.
Remove the paper and reinstall
the duplex unit.
Remove the paper and reinstall
the duplex unit.
Press the stop/clear key.
Exit maintenance mode.
End
Change the setting using the Up/Down keys.
• Increasing the value makes the gap
narrower, decreasing it makes the gap
wider.
• Setting range: –20 - +20
Reference: 0
Changing the value by 1 changes the gap
by 0.3 mm.
A : 1 mm
Paper
Side registration
front guide
Side registration
rear guide
Figure 3-3-104
To Next Page
Loading...
