2A3/4
3-5-16
Reinsert the connector. Also
check for continuity within the
connector cable. If none, rem-
edy or replace the cable.
Replace the paper conveying
motor and check for correct
operation.
Replace the finisher main PCB
and check for correct opera-
tion.
Adjust the paper conveying
belt so that it is in phase and
check for correct operation.
Replace the paper conveying
belt clutch and check for cor-
rect operation.
Replace the paper conveying
belt home position sensor and
check for correct operation.
Reinsert the connector. Also
check for continuity within the
connector cable. If none, rem-
edy or replace the cable.
Check whether the internal
tray unit or front cover catches
are damaged.
The paper
conveying
motor con-
nector makes
poor contact.
The paper
conveying
motor mal-
functions.
Defective fin-
isher main
PCB.
The paper
conveying
belt is out of
phase.
The paper
conveying
belt clutch
malfunctions.
The paper
conveying
belt home
position sen-
sor malfunc-
tions.
The paper
conveying
belt home
position sen-
sor connector
makes poor
contact.
The internal
tray is incor-
rectly in-
serted.
C801
C803
Finisher paper conveying
motor problem*
2
• The paper conveying mo-
tor lockup signal is de-
tected for 0.5 s or longer.
Finisher paper conveying
belt problem*
2
• An on-to-off or off-to-on
state change of the paper
conveying belt home posi-
tion sensor is not detected
within 2 s of the paper con-
veying belt clutch turning
on.
Code Contents
Remarks
Causes
Check procedures/
corrective measures
*2: optional.
To Next Page
Loading...
