5
2. Set-up
2-3 Installing the software
Perform the following procedure to install into your computer the
printer driver and other software that is appropriate to the operating
system in use in that computer. For information on installing the
required software, refer to the Functions Edition.
2-2 Connecting the network cable
To connect the printer to a network, use an Ethernet cable (100Base-
TX or 10Base-T).
Turn the main switch located on the left side of the printer
OFF (O).
Connect the network cable to the Ethernet connector at the
back of the right side of the printer.
Connect the other end of the network cable to your hub.
Turn the printer’s main switch back ON ( | ).
Make network settings. (See “Network settings” on page 6.)
1
2
3
4
5
To Next Page
Loading...
