Kyocera KM-8030 - Page 177

2FB/2FC-4
1-5-18
(24)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
2).
Jam code 41
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(25)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
3).
Jam code 42
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(26)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
4).
Jam code 43
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(27)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
5).
Jam code 44
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(28)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
6).
Jam code 45
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(29)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
7).
Jam code 46
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(30)
A paper jam in the
eject section is indi-
cated during copying
(jam in eject section).
Jam code 50
Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Problem
Causes/check procedures Corrective measures