Kyocera TASKalfa 1800 - Abnormal Image

2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-4-65
(17) Abnormal image
1. Table scanning
2. DP-scanning
Print example
Defective part Check description Corrective Action
1
FFC cable CIS Check the FFC cable between
the CIS and main/engine PWB is
properly connected. Or, verify
conduction of the wire.
Reinsert the connector if its connection is
loose. Or, if conduction is lot, replace the wire.
2
CIS The CIS is defective. Replace the CIS and perform U411.
(see page 1-3-75)
3
Main/Engine PWB The main/engine PWB is defec-
tive.
Replace the main/engine PWB.(see page 2-2-
11)
Defective part Check description Corrective Action
1
FFC cable CIS Check the FFC cable between
the CIS and main/engine PWB is
properly connected. Or, verify
conduction of the wire.
Reinsert the connector if its connection is
loose. Or, if conduction is lot, replace the wire.
2
CIS The CIS is defective. Replace the CIS and perform U411.
(see page 1-3-75)
3
Main/Engine PWB The main/engine PWB is defec-
tive.
Replace the main/engine PWB.(see page 2-2-
11)