Copying Functions
4-2 OPERATION GUIDE
Original Size
Specify the size of originals being scanned. Be sure to specify the original size when copying non-standard
sizes.
The following options are available.
1 Press the Copy key.
2 Place the originals on the platen.
Item How to Select Sizes
Standard
Sizes 1
Have the size of
original detected
automatically, or
select from the
standard sizes.
Inch models: Auto, Ledger, Legal,
Letter, Letter-R, Statement,
Statement-R, 8.5×13.5", Oficio II and
11×15"
Metric models: Auto, A3, B4, A4,
A4-R, B5, B5-R, A5, A5-R, B6, B6-R,
A6-R and Folio
Standard
Sizes 2
Select from the
standard sizes
not included in
the Standard
Sizes 1 .
Inch models: A3, B4, A4, A4-R, B5,
B5-R, A5, A5-R, B6, B6-R, A6-R,
Folio, 8K, 16K and 16K-R
Metric models: Ledger, Legal, Letter,
Letter-R, Statement, Statement-R,
8.5×13.5", Oficio II, 11×15", 8K, 16K
and 16K-R
Others Select from
envelope,
postcard or the
custom sized
originals*.
* For instructions on how to specify the custom original sizes
(Custom 1 to 4), refer to Custom Original Size Setup on page
8-5.
** The input units can be changed in the System menu.
Refer to Switching Unit of Measurement on page 8-15.
Use the procedure below to select the original size.
Hagaki, Oufuku Hagaki, Custom 1 to
4
Size Entry Enter the size
not included in
the standard
sizes 1 and 2**.
Inch models
Horizontal: 2 to 17" (in 0.01"
increments), Vertical: 2 to 11.69" (in
0.01" increments)
Metric models
Horizontal: 50 to 432 mm (in 1 mm
increments), Vertical: 50 to 297 mm
(in 1 mm increments)
To Next Page
Loading...
