Default Setting (System Menu)
8-66 OPERATION GUIDE
Date/Timer
Date/Timer settings include:
• Date/Time …8-66
• Date Format …8-67
• Time Zone …8-67
• Auto Panel Reset …8-67
• Low Power Timer …8-68
• Auto Sleep …8-69
• Auto Error Clear …8-69
• Interrupt Clear Timer …8-70
NOTE: If user login administration is enabled, you can only change the settings by logging in with
administrator privileges.
Date/Time
Set the date and time for the location where you use the machine. If you perform Send as E-mail, the date and
time set here will be displayed on the header.
CAUTION: Be sure to set Time Zone before the Date/Time setup.
Use the procedure below to set the date and time.
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Change] of
Date/Time.
3 Press [+] or [–] to enter the date and time
respectively.
\
NOTE: If you try to change the date/time when a trial
application (page 8-104) is running, the If you change
Date/Time setting, trial functions will be unavailable.
Are you sure? message is displayed. To change the
date/time, press [Yes].
To Next Page
Loading...
