Kyocera TASKalfa 2550ci - Page 263

2MV
1-4-7
4911 Bridge conveying sensor 1
stay jam
The bridge conveying sensor 1 (BRCS1) does not
turn off during paper feed from cassette 1.
I
4912 The bridge conveying sensor 1 (BRCS1) does not
turn off during paper feed from cassette 2.
I
4913 The bridge conveying sensor 1 (BRCS1) does not
turn off during paper feed from cassette 3.
I
4914 The bridge conveying sensor 1 (BRCS1) does not
turn off during paper feed from cassette 4.
I
4918 The bridge conveying sensor 1 (BRCS1) does not
turn off during paper feed from duplex section.
I
4919 The bridge conveying sensor 1 (BRCS1) does not
turn off during paper feed from the MP tray.
I
5001 Bridge conveying sensor 3
non arrival jam
The bridge conveying sensor 3 (BRCS3) does not
turn on during paper feed from cassette 1.
I
5002 The bridge conveying sensor 3 (BRCS3) does not
turn on during paper feed from cassette 2.
I
5003 The bridge conveying sensor 3 (BRCS3) does not
turn on during paper feed from cassette 3.
I
5004 The bridge conveying sensor 3 (BRCS3) does not
turn on during paper feed from cassette 4.
I
5008 The bridge conveying sensor 3 (BRCS3) does not
turn on during paper feed from the duplex section.
I
5009 The bridge conveying sensor 3 (BRCS3) does not
turn on during paper feed from theMP tray.
I
5011 Bridge conveying sensor 3
stay jam
The bridge conveying sensor 3 (BRCS3) does not
turn off during paper feed from cassette 1.
I
5012 The bridge conveying sensor 3 (BRCS3) does not
turn off during paper feed from cassette 2.
I
5013 The bridge conveying sensor 3 (BRCS3) does not
turn off during paper feed from cassette 3.
I
5014 The bridge conveying sensor 3 (BRCS3) does not
turn off during paper feed from cassette 4.
I
5018 The bridge conveying sensor 3 (BRCS3) does not
turn off during paper feed from duplex section.
I
5019 The bridge conveying sensor 3 (BRCS3) does not
turn off during paper feed from the MP tray.
I
6023 Staple cover open The staple cover is opened during operation.
-
6043 DF top cover open The DF top cover is opened during operation.
-
6103 DF paper conveying sensor
non arrival jam
The paper conveying sensor (PCS) does not
turned on even if a specified time has elapsed after
the machine eject signal was received.
K
Code Contents Conditions
Jam
location*
*: Refer to figure 1-4-1 for paper jam location (see page 1-4-1).