Kyocera TASKalfa 2550ci - Page 433

2MV-C
2-2-8
14. Toner motor M (TM-M) .......................... Replenishes toner to the developer unit M.
15. Toner motor K (TM-K) ........................... Replenishes toner to the developer unit K.
16. Polygon motor Y (PM-Y) ...................... Drives the polygon mirror Y.
17. Polygon motor C (PM-C)...................... Drives the polygon mirror C.
18. Polygon motor M (PM-M)..................... Drives the polygon mirror M.
19. Polygon motor K (PM-K) ...................... Drives the polygon mirror K.
20. Fuser press release motor (FPRM) ...... Drives the pressure release system of the fuser.
21. Controller fan motor (CONFM).............. Cools the controller section.
22. Transfer belt release motor (TCBRM)... Drives the transfer belt release.
23. ID shutter motor (IDSM)........................ Drives the ID sensor cleaning section.
24. LSU cleaning motor (LSUCM) .............. Drives the LSU cleaning section.
25. Container / IH coil fan motor
(C/IHCFM)............................................. Cools the containers and the IH coil.
26. Developer fan motor 1 (DEVFM1) ........ Cools the developer section.
27. Developer fan motor 2 (DEVFM2) ........ Cools the developer section.
28. Developer fan motor 3 (DEVFM3) ........ Cools the developer section.
29. LSU fan motor (LSUFM) ....................... Cools the LSU section.
30. Power source fan motor (PSFM) .......... Cools the power source PWB.
31. Fuser fan motor 1 (FUFM1) .................. Cools the fuser and eject sections.
32. Fuser fan motor 2 (FUFM2) .................. Cools the fuser and eject sections.
33. Imaging fan motor (IMGFM).................. Cools the imaging section.
34. IH fan motor (IHFM) .............................. Cools the IH PWB.
35. DP paper feed motor (DPPFM)............. Drives the original feed section.
36. DP switchback motor (DPSBM) ............ Drives the original switchback section.
37. Eject fan motor (EFM)........................... Disperses steam.