2MV
1-2-25
22. Refit the hard disk using two screws.
23. Connect two connectors to the connec-
tor (YC1 and YC27) of main PWB.
24. Put the wire in the wire guide and then
fix it using four wire holders.
25. Fit the controller box cover using fifteen
screws.
26. Fit the ISU rear cover using two screws.
27. Fit the right upper cover.
Note: Pass the connector of the key
counter wire through the aperture (right
side) in the right upper cover.
Note: Be careful not to put a key
counter electric wire with the upper right
cover.
28. Fit the ISU right cover using two
screws.
Figure 1-2-34
29. Insert the projection of the key counter
cover retainer in the aperture of the
right upper cover.
30. Fit the key counter cover retainer using
the two M4 x 10 screws.
Figure 1-2-35
Screw
Screw
Wire holder
Wire holder
Wire guide
Wire holder
Connector (YC27)
Connector (YC1)
Hard disk
Right upper cover
Aperture
Key counter
cover retainer
M4 x 10 screw
M4 x 10 screw
Projection
To Next Page
Loading...
