2LK/2LN/2LM/2LC-2
1-5-49
1-5-7 PWBs
(1) Detaching and refitting the main PWB
Procedure
1. Remove the rear upper cover (see page
1-5-65).
2. Open the controller lid.
3. Remove two screws.
4. Unhook six hooks and then remove the
left upper cover.
Figure 1-5-77
5. Release six wire saddles on the control-
ler box.
6. Remove the wire holder.
Figure 1-5-78
Screws
Controller lid
Left uppe
cover
Left upper cover
Hooks
Hooks
Hook
Wire holder
Wire saddle
Wire saddles
Wire saddle
Controller box
Wire saddle
To Next Page
Loading...
