10
Warning Message
If the encryption code information of the machine has been lost for some reason, the screen shown here appears
when the power is turned on.
Follow the steps below.
1 Press [Encryption Code], and enter the encryption
code that was entered during the installation of the
security kit.
CAUTION: Even though entering a different
encryption code can also enable continuation of a job,
this will overwrite all the data stored in the hard disk.
Exercise extreme caution when entering an encryption
code.
The encryption code is not the same as the security
password.
2 Press the Power key and confirm that the Power
key/indicator and the memory indicator are off.
After that, turn the main power switch off and on.
To Next Page
Loading...
