Default Setting (System Menu)
8-42 OPERATION GUIDE
Adjustment/Maintenance
Adjust printing quality and conduct machine maintenance.
• Copy Density Adjustment …8-42
• Send/Box Density Adjust …8-42
• Print Density …8-43
• Drum Refresh …8-43
• Correcting Fine Black Lines …8-44
• System Initialization …8-44
• Display Brightness …8-44
• Silent Mode …8-45
• Charger Auto Cleaning …8-45
• Auto Color Correction...8-45
• Gray Adjustment...8-46
NOTE: If user login administration is enabled, you can only change the settings by logging in with
administrator privileges.
Copy Density Adjustment
Adjust copy density. Adjustment can be made in 7 levels both in auto and manual density modes.
Use the procedure below to adjust the copy density.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance] and [Next] of Copy Density Adjustment.
3 Press [Change] of Auto or of Manual.
4 Press [-3] - [+3] (Lighter-Darker) to adjust density.
5 Press [OK].
Send/Box Density Adjust
Adjust scan density when sending or storing the data in Document Box. Adjustment can be made in 7 levels
both in auto and manual density modes.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance] and [Next] of Send/Box Density Adjust..
3 Press [Change] of Auto or of Manual.
4 Press [-3] - [+3] (Lighter-Darker) to adjust density.
5 Press [OK].
To Next Page
Loading...
