OPERATION GUIDE Appendix-17
Curl: Most paper naturally tends to curl after the package is opened. When paper passes through the fixing unit,
it curls upward slightly. To deliver flat printouts, load the paper so that the curl faces towards the bottom of the
paper tray.
Static electricity: During printing, paper is electrostatically charged so that the toner adheres. Choose paper
that can be discharged quickly so that copies do not cling together.
Whiteness: Paper whiteness affects print contrast. Use whiter paper for sharper, brighter copies.
Quality: Machine problems may occur if sheet sizes are not uniform or if corners are not square, edges are
rough, sheets are uncut, or edges or corners are crushed. In order to prevent these problems, be especially
careful when you cut the paper yourself.
Packaging: Choose paper that is properly packaged and stacked in boxes. Ideally, the packaging itself should
have been treated with a coating to inhibit moisture.
Specially treated paper: We do not recommend printing onto the following types of paper, even if it conforms
to the basic specifications. When you use these kinds of paper, purchase a small amount first as a sample to
test.
• Glossy paper
• Watermarked paper
• Paper with an uneven surface
• Perforated paper
Special Paper
This section describes printing onto special paper and print media.
The following paper and media can be used.
• Transparencies
• Preprinted paper
• Bond paper
• Recycled paper
• Thin paper (from 60 g/m
2
to 64 g/m
2
or less)
• Letterhead
• Colored paper
• Prepunched paper
• Envelopes
• Cardstocks (Hagaki)
• Thick paper (from 106 g/m
2
to 200 g/m
2
or less)
• Labels
• High-quality paper
When using these paper and media, choose that are designed specifically for copiers or page printers (such as
laser printers). Use the multi purpose tray for transparencies, thick paper, envelopes, cardstocks, and label
paper.
To Next Page
Loading...
