Kyocera TASKalfa 5551ci - DF Staple Motor Error

2L6/2N6/2N5/2N4
1-4-179
8230 DF staple motor error 1
Staple JAM (DF) has been
detected twice in a row. (The
second JAM detection
condition fullfilled with the
home position did not
detected in 600 ms after the
motor was driven.)
DF staple motor
1. Remove the staple unit and check that
stapling is possible without a jam.
2. Confirm that the FFC wiring connector is
not distorted and connect the FFC wiring
all the way in.
Staple unit and DF main PWB (YC17)
(4000-sheet finisher)
Staple unit and DF main PWB (YC11)
(1000-sheet finisher)
3. If the wiring is disconnected, shorted or
grounded, replace the wiring.
4. Replace the staple unit. (Refer to the
service manual for the document
finisher).
DF staple sensor Replace the staple unit.
DF main PWB Replace the DF main PWB (Refer to the
service manual for the document finisher).
Code Contents Related parts
Check procedures/
corrective measures