Kyocera TASKalfa 5551ci - Coin Vender Pay-Out Error; Coin Vender Pay-Out Sensor Error; ISC PWB Error

2L6/2N6/2N5/2N4-1
1-4-195
9140 Sensor error in coin vender
change (Yen 100)
Change is empty despite
change is enough.
Coin jam in the
change tube
Check visually and remedy.
Contact in the
connector
Check the connection of the empty change
sensor.
Change empty
sensor
Replace the coin mec.
Coin vender control
PWB
Replace the coin mec.
9150 Sensor error in coin vender
change (Yen 500)
Change is empty despite
change is enough.
Change tube Check no exchange jam is observed at the
outlet and, if necessary, repair it.
Contact in the
connector
Check the connection of the empty change
sensor.
Change empty
sensor
Replace the coin mec.
Coin vender control
PWB
Replace the coin mec.
9160 Coin vender pay-out error
Coin is paid out despite the
pay-out motor is determined
not active.
Pay-out motor Replace the coin mec.
9170 Coin vender pay-out sensor
error
Coin is paid out despite the
pay-out motor is determined
not active.
Pay-out area Check no exchange jam is observed at the
outlet and, if necessary, repair it.
Pay-out motor Replace the coin mec.
Pay-out sensor Replace the coin mec.
9500 ISC PWB error A
Main PWB
ISC PWB
1. Reinsert the connector if its connection
is loose.
Main PWB (YC25) and ISC PWB (YC4)
2. Replace the main PWB (see page 1-5-
72).
3. Replace the ISC PWB
4. Contact the Service Support.
9510
ISC PWB error B
Main PWB
DP SHD PWB
1. Reinsert the connector if its connection
is loose.
DP relay PWB (YC2) and DP SHD PWB
(YC3)
2. Replace the main PWB (see page 1-5-
72).
3. Replace the DP SHD PWB.
4. Contact the Service Support.
Code Contents Related parts
Check procedures/
corrective measures