Kyocera TASKalfa 5551ci - Paper Jam: Duplex Re-feeding (Electrical)

2L6/2N6/2N5/2N4
1-4-49
(6) Paper jam at the duplex re-feeding part
Electrical parts that could cause paper jam during paper travelling at the primary
feeding (to regist roller)
Timing of detection
Corrective Action
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only.
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only.
Jam code
J0508,J0518
Related parts
Paper feed motor(PFM)
* : 30 ppm model /35 ppm model
only.
Engine PWB (EPWB)
Duplex clutch 2 (DUCL2)
*1
Duplex motor 2 (DUM2)
*2
Feed PWB 1 (FPWB1)
Duplex sensor 2 (DUS2)
Checking
procedure at the
occurrence of
J05X8
Corrective action at the occurrence of
J05X8
On/Off control signal output connector
(terminal), point of checking connection
1 Items for Initial Checks see page 1-4-29
2
Duplex sensor 2 (DUS2): Conduct
connectivity check, mounting location
check, operation check (U031)
Feed PWB 1 YC 14-5
3
Duplex clutch 2 (DUCL2)
*1
Duplex motor 2 (DUM2)
*2
: Operation
check (U032/30)
Feed PWB 1 YC 14-12 / YC14-14 to 17
4
Check that the drive from the paper feed
motor is transferred to the duplex roller.
* : 30 ppm model /35 ppm model
only.
5
Feed PWB 1 : Replace
6
Engine PWB : Replace