5-16
Using Convenient Fax Functions > Subaddress Box Function
Sub Address Transmission
To specify a Subaddress Box when sending a fax, follow the steps below.
For the setting method when the machine receives originals, refer to the following:
Subaddress Box Function (page 5-9)
1
Select [Fax] on the Home screen.
2
Place the originals.
3
Specifying destination.
Use the numeric keys to enter the destination fax number.
4
Configure the function.
1 [Detail] > [Sub Address]
2 Select “Sub Address” input box, enter the sub address using the numeric keys.
You can use up to 20 digits including the numbers from 0 to 9, ‘ (space)’, ‘#’ and ‘*’
characters to enter a sub address.
3 Select “Password” input box, enter the sub address password using the numeric keys.
You can use up to 20 digits including the numbers from 0 to 9, ‘ (space)’, ‘#’ and ‘*’
characters to enter a sub address password.
4 [OK] > [OK]
5
Send Start.
Check the destination and press the [Start] key.
To use sub address transmission, check that a sub address and password have been set in the receiving system
in advance.
Encrypted transmission cannot be used in sub address transmission.
When a sub address has been registered to the destination of the Address Book, you
can use the destination. When a sub address-registered destination in the Address
Book is used for a One Touch Key, you can also use the One Touch Key.
When [On] is selected in [Dest. Check before Send], a destination confirmation screen
is displayed when you press the [Start] key.
Confirmation Screen of Destinations (page 7-13)
To Next Page
Loading...
