3-2
Sending Faxes > Basic transmission procedure
Basic transmission procedure
The basic procedure for using the fax system is explained below.
1
Select [Fax] on the Home screen.
The base screen for fax appears.
2
Place the originals.
For placing originals, refer to the following:
3
Select the transmission method.
There are two transmission methods: memory transmission and direct transmission.
Memory transmission: The original is scanned into memory before communication
starts. Memory transmission is selected by default.
Direct transmission: The destination is dialed and communication starts before the
original is scanned.
Select [Direct] to change the transmission method to direct transmission. The key will be
highlighted on the touch panel. If the [Direct] is selected in the highlighted state,
the transmission method will change to memory transmission.
4
Specifying destination.
Specify the transmission destination.
5
Selecting the functions.
Select the tab, and set transmitting functions that can be used.
Machine’s Operation Guide
Fax Direct Transmission (page 3-26)
Methods For Entering the Destination (page 3-7)
FAX transmission functions (page 3-18)
To Next Page
Loading...
