Kyocera TASKalfa MA4500ci - Setting the Delayed Transmission; Cancelling Delayed Transmissions (Queued); Immediate Transmission; Continuous Scan

3-25
Sending Faxes > Setting the Delayed Transmission
Setting the Delayed Transmission
Cancelling Delayed Transmissions (Queued)
To cancel delayed transmissions that are queued, use the procedure below.
1
Display the screen.
[Status/Job Cancel] key > [Sending Jobs] > [Scheduled]
2
Canceling a job.
Select the job you want to cancel and select [Cancel] > [OK].
The selected job is deleted.
Immediate transmission
To send delayed transmissions immediately rather than waiting for the specified time, use the procedure below.
1
Display the screen.
[Status/Job Cancel] key > [Sending Jobs] > [Scheduled]
2
Immediate transmission.
Select the job you want to send by immediate transmission, and select [ Start Now ] > [ Start ].
The transmission will start.
Continuous Scan
Scans a large number of originals in separate batches and then produce as one job.
Originals will be scanned continuously until you select [Finish Scan].
You can set the functions that appear on the screen during scanning.
(Value: [Off] / [On])
NOTE
When scanning and sending source documents on the platen, you can always set Continuous Scan.
Always Continuous Scan with Platen (page 8-11)