Kyocera Taskalfa Pro 15000c - Page 124

3-46
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
18
Remove inner cover [A] (Screw x5). The screw will use in step 25.
19
Remove the rear cover [A] (Screw x8). The screw will use in step 27.
20
Adjust the height.
1 Loosen 8 screws [A] on the left front and rear. Turning the bolt [B] clockwise makes AK unit higher and
counterclockwise makes it lower.
[A]
[A]
[A]
[A]
[B]