3-92
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
130
Store the tab sheet fence [A] as shown. Also store the end fence [B] here if the
customer does not need to use it at this time.
Installing the Motor on the paper feeder
131
Lift the rear left cover [A] of the paper feeder slightly and remove it (screw x6). These
screws are used in Step 134.
132
Lift the rear right cover [A] slightly and remove it (screw x10). These screws are used
in Step 134.
• This step can be skip if the cover [A] is already open.
To Next Page
Loading...
