3-93
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
133
Attach the stepping motor assembly [C] while attaching the timing belt: M140 [B] to
the pulley [A] and stepping motor (screw x2: M4x8, connector x1).
134
Re-attach the covers. These screws are used in Step 131 and in Step 132.
• This step can be skip if the cover [A] is already open.
• The stepping motor assembly, timing belt: M140 and fixing screws are provided with AK-9140.
• If Bridge Kit for Paper Feeder (AK-9130) is not completed (until step88) then skip this procedures.
• When attaching the rear left cover, hang it on the hook.
To Next Page
Loading...
