3-97
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
8
Hang the two joint plates [A] (provided with this option) in the gap under the
extension tray.
9
Move each joint plate [A] under the base tray edges and then fix them to the base tray
(screw x1 each: M4x6). Fixing screws are provided with this option.
10
Insert the cover [A] separated in step 6 between the extension tray and base tray, and
then fix it (screw x4: M4x6). To fix it, use the screws that were removed in Step 6.
(screw ×4: M4×6)
11
Pull the extension tray [A], then hang it on the screws as shown below.
To Next Page
Loading...
